If you don’t like to cut the wires of your machine you can use the motor jumper wire provide by the kit
to connect the new extruder motor to your machine. Plus one 8-PIN aviation plug wire for connect the
DDE print head to CR-10s control box.
8-PIN aviation plug for CR-10S print head
Pin1 Heater cartridge RED
Pin2 Heater cartridge YELLOW
Pin3 Thermistor BROWN
Pin4 Thermistor GRAY
Pin5 Hotend fan+ BLACK
Pin6 Hotend fan- WHITE
Pin7 Part cooling fan+ BLUE
Pin8 Part cooling fan- GREEN
To Next Page
Loading...
