11. Preheating Method 预热方法
>>
>>
Method 2
方法2
Notes:
1、The print preheating standard is adjusted at the factory, PLA preheating standard: nozzle temperature 200 °, hot bed temperature 60 °, ABS
preheating standard: nozzle temperature 240 °, hot bed temperature 70 °.If you need to adjust it due to printing materials or other reasons, you
can adjust the parameters on the interface home page control → temperature → PLA / ABS preheat setting.
2、In case of replacing used filaments, you need to heat the nozzle and draw out remaining filaments when it is melted. Or, some filaments may
remain in the nozzles, causing blockages and even damage to the extruder.
注意：
1、打印预热参数标准出厂时已调整好，PLA预热标准：喷嘴温度200°，热床温度60°，ABS预热标准：喷嘴温度240°，热床温度70°。若因打印材料或其他原
因需要调整，可以在界面首页控制→温度→PLA/ABS预热设置进行参数调整。
2、当更换耗材时，需要对喷头加热，待耗材融化后可以顺利抽出喷头中残留耗材。如果不加热喷头直接拔出耗材，可能残留部分耗材在喷头内，造成堵头甚至挤
出机损坏。
0.0
0.0
0.0
0.0
0.0
0.0
100
200 60
100
200 60
15
To Next Page
Loading...
