Creality K1 User Manual

10
Assembly
1. Retrieve the touch screen from the toolbox. Connect the touch screen to the flat
cable extending from the base, following the instructions in Figure A. Gently fit the
touch screen into the designated slot on the baseplate, as illustrated in Figure B.
(Ensure alignment with the indicated direction to prevent any potential damage to
the screen interface.)
Caution:
• Exercise Caution: Avoid powering up the machine while connecting or
disconnecting the touch screen to prevent potential issues.
• Handle with Care: When handling the flexible flat cable of the base, ensure
gentle pulling to prevent damage.
• Power Supply Precautions: Prior to connecting the power supply, verify the
correct positioning of the power supply switch and mains voltage. This
precaution is crucial to prevent any damage to the device.
• Voltage Selection (100V-120V): For mains voltages ranging between 100V
and 120V, use a straight screwdriver to set the power supply switch to 115V.
• Voltage Selection (200V-240V): If the mains voltage falls between 200V and
240V, use a straight screwdriver to set the power supply switch to 230V
(default setting).
By adhering to these precautions, you'll ensure the safe and proper functioning of the
device while minimizing the risk of damage.
Push
Down

Creality K1 Specifications

General

Build Volume	220 x 220 x 250 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Max Hot End Temperature	300°C
Supported Filaments	PLA, ABS, PETG, TPU
Display	4.3-inch Touchscreen
Power Supply	350W
Machine Dimensions	355 x 355 x 480 mm
Printing Speed	600 mm/s
Connectivity	Wi-Fi, USB
Max Bed Temperature	100°C
Chamber Temperature	Not actively heated