Creality TL4800 - Page 11

2.8.2 Take the CR10 V3 as an example. After selecting the model to enter the
flashing guide page. Please connect the printer to the screen terminal with a USB
cable.
2.8.3 After clicking Next step, the Creality Sonic Pad will start flashing the firmware
to the printer and wait for the flashing to complete.
2.9 Printer firmware flashing (update BootLoader)
Pleasenotethat if the printerwithatmega1284pchipcannotsuccessfullyflash
thefirmware,youneedtoupdatetheBootLoaderofthemotherboardfirst,and
then flash the firmware. For the BootLoader update tutorial, please check the
officialwebsite.
https://www.creality.com/pages/download Ecosystem
07