Please refer to the printer adaptation guide link.
How to compile firmware and modify configuration files for non-de-
fault printers ?
The model should be selected according to the actual situation when booting up or one-touch
change. The motherboard version needs to be disassembled to check, and the corresponding
relationship between the four choices of Ender-3 V2
a.[CR Touch logo in the upper left corner of the model diagram]Ender-3 V2 (V4.3.1 or
V4.2.2)----Corresponding to the model with CR Touch installed, the motherboard version is
V4.3.1 or V4.2.2
b.Ender-3 V2 (V4.3.1 or V4.2.2) ----Corresponding to the model without CR Touch installed, the
motherboard version is V4.3.1 or V4.2.2
c.Ender-3 V2 (V4.2.7) ----Corresponding to the model without CR Touch installed, the
motherboard version is V4.2.7
d.[CR Touch logo in the upper left corner of the model diagram]Ender-3 V2 (V4.2.7) ----Corre-
sponding to the model with CR Touch installed, the motherboard version is V4.2.7
What should I do if the Ender-3 V2 cannot be connected during the
booting operation or one-touch change?
Please save the file in a USB disk and insert it into the Creality Sonic Pad USB interface to read
the corresponding file.
The SD card is inserted into the printer, but the corresponding file
cannot be found in the Creality Sonic Pad?
Choose a common camera by yourself or refer to the recommended camera list provided by
Creality:
1 Logitech 920
2 Logitech C270i
3 HIKVISION DS-E12
4 Blue Enchantress T3300
5 PHILIPS SPL6506BM
6 X-LSWAB M600
How to choose a camera?
Creality sonic pad temporarily does not support resume printing function.
Why can't resume printing after a power outage?
The photographic file will not be generated until the printing of the file model is completed.
The time-lapse photographing file cannot be generated if the printing is stopped, powered off,
or the camera is pulled out.
How to generate time-lapse photography files?
30
To Next Page
Loading...
