Crest Audio CR4 - Scuba Mode Settings: Sampling and Logging; Sampling Rate and Log Start Settings

Page 28
1.4.2 Scuba Mode Settings
activate: long beeping repeated three
times with vibration.
Default: 50 minutes
Setup range:
0 minute – 90 minutes
Description: Sampling Rate
To Access: Under Scuba Preview Mode,
press UP Button Or from SETTINGS,
press UP Button / DOWN Button to locate
the cursor at SAMPLING and then press
MODE Button to select.
One of the sampling options will be
blinking at the bottom. Press the Up or
Down buttons to select other sampling
options as needed. Press the MODE
button to accept your selection.
Default: 10 seconds
Setup range:
10 seconds / 20 seconds / 30 seconds /
60 seconds
Note:
This setting will automatically apply to
Gauge Mode.
Description: Log Start at Depth Setting
(Log Start)
To Access: Under Scuba Preview Mode,
press UP Button Or from SETTINGS,
press UP Button / DOWN Button to locate
the cursor at LOG START and then press
MODE Button to select.
One of the log start depth options will be
blinking at the bottom. Press UP Button /
DOWN Button to select other options as