Crestron DM-RMC-4K-SCALER-C - Display Mode Configuration

Supplemental Guide – DOC. 7728A DM-RMC-4K-SCALER-C/-DSP: 4K DigitalMedia 8G+ Receivers
•
9
Video Settings Dialog Box—Standby Timeout Configuration
Configuration Using SIMPL Windows
Using SIMPL Windows, set the standby timeout in slot 3 for the DM-RMC-4K-SCALER-C
Scaler. To do so, set the
<Scaler_Out_Standby_Timeout>
analog input join to the desired
value.
NOTE:
For detailed information, refer to the SIMPL Windows help file.
Display Mode
The display mode of an image can be set to one of the following:
• Maintain aspect ratio
• Stretch to fit
• 1:1 pixel mapping
To configure Display Mode settings, use DMTool or SIMPL Windows as discussed in the
following sections.
Configuration Using DMTool
An overview of the steps necessary to set Display Mode using DMTool follows.
NOTE:
For detailed information, refer to the Crestron Toolbox help file.
1. Connect to the DigitalMedia switcher.
2. Connect to the DM-RMC-4K-SCALER-C.
3. Open the Setup window of the HDMI output.
4. In the Video Settings dialog box, select the desired value in the
Display Mode
drop-down list.