10
DM-RMC-4K-SCALER-C/-DSP: 4K DigitalMedia 8G+ Receivers Supplemental Guide – DOC. 7728A
Video Settings Dialog Box—Display Mode Configuration
Configuration Using SIMPL Windows
Using SIMPL Windows, set the display mode in slot 3 for the DM-RMC-4K-SCALER-C
Scaler. To do so, set the
<Scaler_Out_Display_Mode>
analog input join to the desired
value.
For detailed information, refer to the SIMPL Windows help file.
EDID
EDID (Extended Display Identification Data) configuration allows management of the EDID
that is to be sent to the upstream device connected to the DM 8G+ input of the
DM-RMC-4K-SCALER-C. By default, the EDID is set to
If a
different EDID is desired, use DMTool to configure the EDID. An overview of the steps
necessary to configure the EDID follows.
For detailed information, refer to the Crestron Toolbox help file.
1. Connect to the DM-RMC-4K-SCALER-C.
2. Open the Setup window of the DM input.
3. In the EDID Configuration dialog box, configure the EDID by doing any of the
following:
• Customize the current EDID.
• Load an EDID template and modify it.
• Create a new EDID file.
• Load the existing EDID and modify it.
• Obtain an EDID from the output and then save or customize it.
• Apply an EDID that is saved on a computer.