Crestron DMPS-100/200/300-C/300-C-AEC DigitalMedia Presentation System
Operations Guide – DOC. 7219D DigitalMedia Presentation Systems: DMPS-100/200/300-C/300-C-AEC • 49
Adjust the Auxiliary Output
Startup Volume
The auxiliary output startup volume control is used to establish the auxiliary output’s
volume level setting when an input is selected.
To adjust the auxiliary output startup volume level:
1. Access the “Aux. 1 Output” or “Aux. 2 Output” menu as described on page
45.
2. Press the k or j buttons until Startup Vol. is displayed on the LCD and
press ENTER to display the “Aux. 1 Startup Vol.” menu.
“Aux. 1 Startup Vol.” Menu
Aux. 1 Startup Vol.
k
30% j
3. Adjust the auxiliary output startup volume level with the j and k buttons.
The highest auxiliary output startup volume setting is 100%.
NOTE: While adjusting the auxiliary output startup volume level, the
auxiliary output volume level can be adjusted by turning the VOLUME
control clockwise to raise the volume, or counterclockwise to lower the
volume. When adjusting the volume, the display changes to indicate the
volume level.
4. Press MENU or ENTER to save changes and return to the previous screen.
Input Compensation
The input compensation level of each analog audio input can be set from the
DMPS-100/200/300-C’s front panel. The line outputs are not affected by changes
made to the input compensation level.
Set the
Input Compensation Level
To set the input compensation level for an input:
1. Access the “Audio Setup” menu described on page 40.
2. Press the k or j buttons until Input Compensation is displayed on the
LCD and press ENTER to display the “Input Compensation” menu.
“Input Compensation” Menu
Input Compensation
Analog 1 Comp. j
3. To select the input to adjust, press the k or j buttons until the desired
input is displayed and press ENTER. Inputs include Analog 1 – 5, S/PDIF,
ATC, HDMI 1-5, DM 6 and DM 7.
NOTE: Not all inputs are present on the DMPS-100-C or DMPS-200-C devices.
“Analog In 1 Comp” Menu
Analog In 1 Comp.
k
0dB j