Crestron Mercury CCS-UC-1 - Page 24

18 • CCS-UC-1: Crestron Mercury Tabletop Conference System Supplemental Guide – DOC. 7844E
Required Fields
USER is HOSTED BY SIP ADDRESS and USER
PRINCIPAL NAME (UPN)
REQUIRED FIELDS
On-premises Skype for
Business Server
SIP address and UPN may be the
same
Username:
UPN or domain\username
Password:
Password
SIP Address:
SIP address
Office 365
®
Application
SIP address and UPN are
traditionally the characters before
“@onmicrosoft.com”
Username:
UPN
Password:
Password
SIP Address:
SIP address
1. Set Enable to Enabled.
2. Refer to the table above to determine the required fields and configure the
Username, Password, and SIP Address fields as required.
3. If automatic discovery for mobile clients hasn't been configured, enter the following
information:
• Internal Server Name:
https://webdir.online.lync.com/Autodiscover/autodiscoverservice.svc/Root
• External Server Name:
https://webdir.online.lync.com/Autodiscover/autodiscoverservice.svc/Root
NOTE: If these fields are left blank, the client uses autodiscovery. If the Skype for
Business deployment does not use autodiscovery, these fields should be filled with
the appropriate information.
These addresses are valid only for Office 365 users
and are different for On-premises Skype for Business Server deployments.
4. If the Skype for Business server is behind an HTTP proxy that requires
authentication, select the credentials to be used for the proxy server from the drop-
down list.
• Select None if credentials are not required for authentication.
• Select Same Credentials to use the login credentials configured previously in
step 2.
• Select Other Credentials to use a different set of credentials and enter the user
name and password in the
Proxy Username and Proxy Password fields
respectively.
5. The device can provide up to four speed dial entries. To configure a speed dial
entry, perform the following procedure:
a. Set Enable to Enabled.
b. Enter the “friendly” name of the speed dial entry in the Name field.
c. Enter the email address, phone number, or meeting URL in the Number field.
NOTE: The information entered in the Number field must be formatted for the
selected Type in step d below.
d. Select the type of entry to be assigned from the Type drop-down list.
• Number: Select Number to have the speed dial button dial a phone
number.