Cromtech Outback CTG2500i - Cleaning the Generator; Exterior Cleaning; Storage Location and Covering; Storage and Operation Position

CLEAN THE GENERATOR
1. Clean the exterior part of the generator. Use only damp
cloth with mild detergent. Avoid excess moisture.
2. Store the generator in a dry and well-venlated place,
with a clean cloth covered.
3. The generator must remain in a vercal posion when
stored, carried and operated.
TRANSPORT
When transporng the generator;
1. Do not overll the tank (there should be no fuel in the
ller neck).
2. Do not operate generator while it is on a vehicle. The
generator must be operated in a well venlated area.
3. Avoid pung the generator on a vehicle exposed
directly to sunlight. If the generator is le in an enclosed
vehicle for many hours, the high temperatures inside the
vehicle could cause fuel to vaporize resulng in possible
explosion.
4. Do not drive on a rough road for an extended period
with the generator on board. If you must transport
the generator on a rough road, drain the fuel from the
generator before hand.
5. Ensure Vent knob is turned to the OFF posion.
IDENTIFICATION
The machine idencaon
series number is aached in the
locaon as shown in drawing.
① Machine series number
SERIAL NUMBERS
___ ___ ___ ___ ___ ___
(Write serial no.)
Pg. 32