Cron TP26H - Page 12

  
Chapter 5: Operaon Instrucons
5.3.3 Aer LaBoo5.1.0*soware successfully installed, double-click the icon of
LaBoo5.1.0*soware shortcut on the desktop, the startup interface as shown below
5.3.4 Aer launching the LaBoo5.1.0*, below is the main interface of the soware:
5.3.5 Confirm dongle installaon and informaon:
The dongle and device informaon can be obtained through the dongle icon in the upper right corner of the
soware.
5.3.6 Newly installed soware first need to setup the inial template, click the
“New”green buon (at lower le) to create and setup an inial new template:
Setup a template size within the model specificaon allowable range, confirm "template name", "media
material", "resoluon", "format", "laser power", "exposure speed" and other parameters, as described in
Secon 5.4.1 - Table 5.1.
5.3.7 Click on the Engineer buon to enter to soware’s Engineer Mode. Enter the default
password "cron1234"when in the password field when prompted.
2322
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR