EasyManua.ls Logo

Cron TP26H - Safety and Caution Labels

Cron TP26H
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.5 Safety and Caution labels
WARNING!
DANGER!
Overhead obstacle!
Cauon Electricity!
Do not look straight intothe laser beam!
Beware of hand crush!
Drum is rotating! Do not touch!
Caution hot surface!
Note!
Emergency stop switch!
Chapter 2: Overview
In the use of this device, please strictly comply with the requirements of the warning signs in
the device!
Before using the CTPplease read carefully and understand the manual content.Strictly
follow all safety rules and regulaons process while operang the equipment.Failure to follow
Unauthorized aempts of disassembling or alteraon, and/or misuse, inappropriate operaon
of the equipment hardware or modificaon of its circuitry may result in serious damage or
malfuncon to the imager.
Do not allow the body to come into contact with life current flowing parts of
the device.Put on an-stac gloves to prevent stac or power surge when
handling with electronic or electrical components.Do not touch the power
cord areas and other electrical components with bare hands.Do not operate
Equipment cover opening or closing, be carefulof head collision.
Do not look straight intothe laser beam!Do not look straight
Do not touch the drum while it is rotang the drum, it will
cause injury!
Please open or close the lead cover slowly, and avoid hands
being crushed.
Emergency stop switch is a safety measure funcon; when in an
emergency situaon, where emergency stop switch is pressed to quickly
get the drum stop rotang.This switch is located on the side of the
device top casing. Under normal operaon mode, make sure the
emergency stop switch is disengaged or released.
A. Rotate the switch in the direcon of the arrow to dis-engage
(working mode) the emergency switch.
B. When the device appears abnormal, press the emergency stop
switch, idenfy the cause and Problemhandling before reopening the
emergency stop switch;
Emergency stop switch does not have the funcon of cung off the current power, make sure
to turn off the power of the equipment before systemmaintenance.
Do not touch the high temperature working part of equipment
directly
0908
SIMPLE AND DIRECT STEADY MAJOR
SIMPLE AND DIRECT STEADY MAJOR
光鼓运转时请勿接
DO NOT TOUCH WHEN
DRUM ROTATES
!
危 险
DANGER
!
防 止 开 盖 夹 伤
MIND YOUR HANDS
危 险
DANGER