Cron TP26H - Slip Paper Collector; Straight In-Line Bridge

6.4.2 Slip Paper Collector connecon
6.4 Slip Paper Collector
6.4.1 Slip Paper Collector structure
6.4.3 Slip Paper Collector unit maintenance
6.5.3 Using the Straight In-line Bridge
6.5.4 Straight In-line Bridge maintenance
6.5 Straight In-line Bridge
6.5.2 Straight In-line Bridge connecon
6.5.1 Straight In-line Bridge structure
Air outlet
(nozzles)
Slip paper rollers
Power control cable connecon
Fans
1
6
2
3
4
5
1
6
2
3
4
5
Chapter 6: Oponal Devices
The Slip Paper Collector is an oponal device used to separate slip papers on the H model CTP device, remove
and organize slip papers effecvely, increase the number of single delivery, and reduce the manual intervenon on
slip paper handlings.
Aach the Slip Paper Collector unit under the slip paper outlet path according to the screw holes posion
provided, then connect the power control cable to the port shown below,
a) Regularly clean the air outlet nozzles
b) Regularly check the condions & cleanliness of the slip paper rollers
c) Regularly check the transmission gears lubricants& condions
d) Regularly check the fans operaon
The Straight In-line Bridge is oponal peripheral, aaches to the host CTP device for transporng the CTP
exposed plate output to the processor unit, or it can be a temporary single plate stacker.
a) Note: when ordering the Straight In-line Bridge to be bundled with the
host CTP device, reserved BGP connector port will be replaced with cable
connecon port for Straight In-line Bridge connector.
b) USB port connecon for host CTP device TP26 / TP36 / TP46 / TP60
models can be located on the same connecvity panel as shown in below;
c) For TP72CTP device, the Straight In-line Bridge connector is located
lower le underneath where the bridge installed.
a) Plate Stoppers is closed (flat): bridge is in full working mode. Plate will be transported through the bridge into
the processor unit;
b) Plate Stoppers is opened (flip up): convert bridge become atemporary single plate stacker.
a) Regularly clean the conveyor belt, conveying the upper plane
b) Regularly check bridge level(height) and posion against CTP & processor
c) Regularly check the working mode is valid.
Conveyor belts
Plate stoppers
Bridge connecon cable port
TP72cable connecon port
Bridge installaon bracket
Bridge support arms
3332
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR