6.6.2 Autoloader connecon
a) Conneche provided feeder communicaon cable to the indicated port located next to the US B port
panel of the host CTP device.
b) Connect the power supply cord from the autoloader to the indicated power supply port located next
to the USB port panel of the host CTP device.
6.6 CTP Autoloader
6.6.1 Autoloader structure
6.6.3 Autoloader in Template sengs
a) To enable Autoloader sengs in LaBoo, you need to ck on “Autoloader” in the Template edit
page. The “Autoloader” tap will be available for you to configure the feeder sengs;
b)Sengs for Single Cassee Loader(S CL)：allow 3 kinds of selecon for appropriate slip paper
blowing strengths and paper sucon pressure (Lo, Mid, Hi mode), according to the size of the
media and slip paper weight used in the Autoloader.
Connecvity panel on Host CTP Connecvity panel on Autoloader
6.6.4 Autoloader device operaon and maintenance
For details on the operaon and maintenance on Autoloader (SCL & MCL) devices,
please refer to "User Manual for the Autoloader"
1
2
3
4
5
1
6
2
3
4
5
Chapter 6: Oponal Devices
Plate feeding mechanism
CTP - Feeder connecon port
Daylight shield
Plate cassees
Slip paper collector
3534
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
c) Sengs for Mul-Cassee Loader(MCL): similar like a Single Cassee Loader(SC L),
you can have selecons of paper blowing strengths and paper sucon pressure (Lo, Mid,
Hi mode), according to the size of the media and slip paper weight used in each cassee.
Mul-Cassee Loader(M CL) comes in 3 cassees and 5 cassees models only.
To Next Page
Loading...