3938
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
2、The right frame, the lower crossbeam and the upper crossbeam are connected,
and theconnecon mode is synchronous 1. Picture shows result aer assembly：
3、Connect the Auto Loader Table with the le and right frame.
a）Use six angle screw M6X12+ to connect the simple auto loader table to the support plate block;
b）The gap is located in the non beam measurements
4、Screw the front and back sides of the auto loader table with screws.
5、Connect the paper collector with the screws on the two sides of the receiving frame
aachments, confirm that the slide is smooth before and aer assembly.
6. Aer the installaon is completed, the product should look like in the picture shown
below (for example, G+ equipment, as shown in Figure
To Next Page
Loading...