Crown CE Series Reference Manual

Page 3
CE-Series Amps with an Attitude!
7. Do not attempt to service
this unit beyond instructions
contained in this manual.
Refer all servicing to the
Crown Service Department.
8. Keep your
CE-Series
amplifier away from sources
of heat, such as a radiator or
oven. Do not cover or
surround your amp with
material which may retain
heat, such as a blanket or
curtain.
9. Obtain assistance
from qualified service
personnel if any of the
following occurs:
• The power cord or plug
has been damaged in
any way.
• Foreign objects or
liquid have fallen into
the amplifier enclosure.
• The amplifier has been
exposed to rain or has
been partially or totally
immersed in any liquid.
• The amplifier has been
dropped or the chassis
has been damaged.
• You notice a marked
change in performance,
or your
CE-Series amp
does not appear to
operate normally.
Lightning Bolt Symbol:
This symbol is used to alert the
user to the presence of dangerous
voltages and the possible risk of
electric shock.
Exclamation Mark Symbol:
This symbol is used to alert the
user to make special note of
important operating or maintenance
instructions found in the reference
manual.
Watch for these symbols:
Keep these
instructions
where you can
look at em
later!
10. CAUTION: Do not locate
sensitive, high-gain
equipment such as
preamplifiers or tape
decks directly above or
below the unit. If an
equipment rack is used,
we recommend locating
the amplifier(s) in the
bottom of the rack and
the preamplifier or other
sensitive equipment at
the top.

Crown CE Series Specifications

General

Frequency Response	20 Hz - 20 kHz ±0.5 dB
Signal to Noise Ratio	>100 dB (A-weighted)
Channels	2
Input Impedance	20 kOhms balanced, 10 kOhms unbalanced
Protection	Short circuit, thermal, and DC fault protection