Crown CE Series - 7 Specifications

Page 44
CE-Series Amps with an Attitude!
7 Specifications
Note: All specifications relate to all models of CE-Series ampli-
fiers. All measurements are at 26 dB, 8 ohms, 1 kHz at rated
power unless otherwise stated.
Frequency Response: ±0.1 dB from 20 Hz to 20 kHz at 1 watt.
Phase Response: ±15° from 20 Hz to 20 kHz at 1 watt.
Signal to Noise at 8 Ohms Rated Power: >105 dB A Weighted.
>100 dB from 20 Hz to 20 kHz.
Input Impedance: Nominally 20 K ohms, balanced. Nominally
10 K ohms, unbalanced.
Total Harmonic Distortion: <0.5% at 8 ohms, rated power, from
20 Hz to 20 kHz.
Intermodulation Distortion (60 Hz and 7 kHz at 4:1): <0.1%
from 8 ohms rated power to –35 dB.
Damping Factor: >400 from 10 to 400 Hz.
Crosstalk: >–55 dB from 20 Hz to 20 kHz.
Common Mode Rejection (CMR): >70 dB from 20 Hz to 1 kHz.
DC Output Offset (Shorted Input): ±10 mV.
Voltage Gain,
All Models: 20:1 at maximum level position (26 dB).
CE 1000: 33.5:1 or 30.5 dB at 1.4-volt sensitivity (8 ohms).
CE 2000: 40.4:1 or 32.1 dB at 1.4-volt sensitivity (8 ohms).
Power
CE 1000
Distortion Stereo-per-Channel Bridged-Mono
8
ΩΩ
ΩΩ
Ω 4
ΩΩ
ΩΩ
Ω 2
ΩΩ
ΩΩ
Ω 8
ΩΩ
ΩΩ
Ω 4
ΩΩ
ΩΩ
Ω
0.5% 275 W 450 W 560 W 900 W 1100 W
CE 2000
Distortion Stereo-per-Channel Bridged-Mono
8
ΩΩ
ΩΩ
Ω 4
ΩΩ
ΩΩ
Ω 2
ΩΩ
ΩΩ
Ω 8
ΩΩ
ΩΩ
Ω 4
ΩΩ
ΩΩ
Ω
0.5% 400 W 660 W 975 W 1320 W 1950 W