Crown CE Series - Output Pin Assignments

Page 46
CE-Series Amps with an Attitude!
Input/Output (Spaghetti Control)
Input Connectors: One Neutrik Combo connector for each
channel which features a balanced ¼-inch phone jack and a
3-pin female XLR connector, in parallel with a barrier strip ter-
mination.
Input Stage: Input is electronically balanced and employs pre-
cision 1% resistors.
Input Impedance: Nominally 20 K ohms, balanced. Nominally
10 K ohms, unbalanced.
Input Sensitivity: 1.4 volts for standard 1 kHz power, or fixed
26 dB gain.
Output Connectors: Two Neutrik Speakon
®
NL4MP (mates
withNL4FC) output connectors.
DC Output Offset: ±10 millivolts.
Output Signal
Stereo: Unbalanced, two-channel.
Bridge-Mono: Balanced, single-channel. Channel 1 controls
are active; Channel 2 should be turned down.
Wiring Configuration
OUTPUT ASSIGNMENT
PIN CH PIN CH
1+ 2 1+ 1
1– 2 1– 1
2+ 2+ 2
2– 2– 2
CH - 2 CH - 1
Fig. 7.1
Output Pin
Assignments