CSI CS750 - Monitoring Features (Analog); Advanced Features; Radio Check; Sending a Radio Check

14
4.Press: to Talkaround and press to confirm or press to cancel.
5.After confirmation, the display shows "Talkaround On" OR "Talkaround Off"
6.Press or wait the presetting time to exit the menu state.
The Talkaround setting is retained even after powering down.
Monitoring Features (Analog)
Monitoring a Channel
Use the Monitor feature to make sure a channel is clear before transmitting by listening for
activity on the channel.
Procedure:
1. Press the programmed Monitor button and listen for activity. The monitor icon appears on the
display.
2. If you hear activity on the channel the channel is busy. If you hear "white noise" on the
channel the channel is free.
Advanced Features
Radio Check
If enabled, this feature allows you to determine if another radio is active in a system without
disturbing the user of that radio. No audible or visual notification is shown on the target radio.
This feature is only applicable for subscriber aliases or Ids
Sending a Radio Check
Procedure:
Use the menu.
1. Press to access the menu.
2. Press to Contacts and press to select
3. Press to the required subscriber alias or ID and press to select
OR
Press to Manual Dial and press to select. Key in the subscriber alias or ID and Press.
4. Press to Radio Check and press to select.
5. Wait for acknowledgement
6. If the target radio is active in the system, a tone sounds and the display briefly shows Target
Radio Available.
OR
If the target radio is not active in the system, a tone sounds to show Target Radio Not Available.
7. Radio returns to the subscriber alias or ID screen.
Remote Monitor
Use the Remote Monitor feature to turn on the microphone of a target radio (subscriber alias or
IDs only). No audible or visual indication is given to the target radio. You can use this feature to
monitor, remotely, any audible activity surrounding the target radio. Your radio must be
programmed to allow you to use this feature.
Initiating Remote Monitor
Procedure:
Use the programmed Remote Monitor button.
Use the menu.
1. Press to access the menu.
2. Press to Contacts and press to select
3. Press to the required subscriber alias or ID and press to select