20
Press to Manual Dial and press to select. A blinking cursor appears.
Enter the subscriber ID you want to page and press .
4. Press to Call Alert and press to select.
5. The display shows Call Alert: <Subscriber Alias or ID>, indicating that the Call Alert has been
sent.
6. The RED LED turns on when your radio is sending the Call Alert.
7. If the Call Alert acknowledgement is received, a tone sounds and the display shows Call Alert
Successful.
OR
If the Call Alert acknowledgement is not received, a tone sounds and the display shows Call
Alert Failed.
Emergency Operation
An Emergency Alarm is used to indicate a critical situation. You are able to initiate an
Emergency at any time on any screen display even when there is activity on the current
channel.
Your radio supports 3 Emergency Alarms:
• Emergency Alarm
• Emergency Alarm with Call
• Emergency Alarm with Voice to Follow
In addition, each alarm has the following types:
• Regular - Radio transmits an alarm signal and shows audio and/or visual indicators.
• Silent - Radio transmits an alarm signal without any audio or visual indicators. There will be no
response (call) from the target radio until you press the PTT button to initiate the call.
• Silent with Voice - Radio transmits an alarm signal and is able to receive an incoming call
without any audio or visual indicators until you press the PTT button to initiate or respond to the
call.
Only ONE of the Emergency Alarms above can be assigned to the programmed Emergency
button.
Receiving an Emergency Alarm
Procedure:
1. When receiving an Emergency Alarm, the display shows the Emergency icon, the number of
alarms received, and Alarm Rcvd, which alternates with alias ID of the sender.
2.A tone sounds.
3. If enabled, your radio automatically acknowledges the Emergency Alarm.
When your radio receives an Emergency Alarm, it displays the Emergency Alarm received
indications until acknowledgement is sent and you exit the Emergency mode.
You will not be able to receive any other indications or displays for any other calls until you exit
the Emergency Alarm received screen.
NOTE: Short press, then long press the programmed Emergency button to clear the Emergency
Alarm received indications and exit Emergency mode.
Responding to an Emergency Alarm
Procedure:
When receiving an Emergency Alarm:
1. Press any button to stop all Emergency Alarm received indications.
2. Hold the radio vertically 1 to 2 inches (2.5 to 5.0cm) from your mouth.
If the Channel Free Indication feature is enabled, you will hear a short alert tone the moment the
transmitting radio releases the PTT button, indicating the channel is now available for use.
To Next Page
Loading...