CSI CS750 - Scan Lists; Scan; Starting and Stopping Scan

15
OR
Press to Manual Dial and press to select. Key in the subscriber alias or ID and Press
to select.
4. Press to Remote Mon. and press to select.
5. Wait for acknowledgement
6. The display shows Remote Monitor Successful.
OR
The display shows Remote Monitor Failed.
7. If successful:
The radio starts receiving audio from the monitored radio for a programmed duration.
Once the timer expires, the radio sounds an alert tone.
The display shows Remote Monitor Ended.
OR
If unsuccessful:
The radio repeats the attempt until the programmed number of tries expires.
Scan Lists
Scan lists are created and assigned to individual channels/groups. Your radio scans for voice
activity by cycling through the channel/group sequence specified in the scan list for the current
channel/group.
Your radio can support up to 250 scan lists. A scan list can contain 31 channels in addition to
the selected channel. Each scan list supports a mixture of both analog and digital entries.
You can add, delete, or prioritize channels by editing a scan list.
Procedure:
1. Press to access the menu.
2. Press to Scan and press to select
3. Press to View/Edit List and press to select
4. Press to view each member on the list.
Scan
When you start a scan, your radio cycles through the programmed scan list looking for voice
activity. The LED blinks Orange while in scan mode. During a dual mode scan, if you are on a
digital channel, and your radio locks onto an analog channel, it automatically switches from
digital mode to analog mode for the duration of the call. This is also true for the reverse.
There are two ways of initiating scan:
• Main Channel Scan (Manual): Your radio scans all the channels/groups in your scan list. On
entering scan, your radio may, depending on the settings, automatically start on the last
scanned "active" channel/group or on the channel where scan was initiated.
• Auto Scan (Automatic): Your radio automatically starts scanning when you select a
channel/group that has Auto Scan enabled.
Starting and Stopping Scan
Procedure:
Press the programmed Scan button to start or stop Scan.
OR
Follow the procedure below.
1. Use the Channel Selector Knob to select a channel programmed with a scan list.
2. Press ' to access the menu.
3. Press to Scan and press to select
4. The display shows Turn On if scan is disabled.
OR