CTC Union GSW-3424M User Manual

Chapter 6. Manage / Configure the Switch
33
dot1x timeout re-authperiod x command is used to set the timeout period for doing re-authentication process. The
valid value of “x” is 0~65535.
dot1x timeout server-period x command is used to set the request timeout value between the switch and RADIUS
server. The valid value of “x” is 0~65535.
dot1x timeout supplicant-period x command is used to set the timeout value between the switch and users (called
“supplicant” in 802.1x) after first identification. The valid value of “x” is 0~65535.
dot1x timeout tx-period x command is used to set the timeout value for the identification request from the switch
to users. The request will be re-tried until the authcount is met. After that, authentication fail message will be sent.
The valid value of “x” is 0~65535.
Note
:
1. Setting 802.1x function on ports, use “dot1x” command in interface configuring mode.
2. Setting for RADIUS server, use “radius-server” command.
Please refer to sections for the commands.
10 end command
This command is used to exit from configure mode.
11 hostname command
This command is used to set the name of the switch in network. This name is also used as the hostname for SNMP
agent function of the switch.

CTC Union GSW-3424M Specifications

General

Brand	CTC Union
Model	GSW-3424M
Category	Switch
Language	English