Chapter 6. Manage / Configure the Switch
43
rate-limit mode command is used to disable “Packet Drop of Ingress Limit” function. When Ingress traffic rate
exceeds Ingress Rate Limit, the switch can drop packets or pause the traffic. If packet drop is enabled, flow control of
ports will be disabled and packets could be dropped. If packet drop is disabled, flow control of ports will be enabled
and pause frame will be sent when ingress traffic rate exceeds the limit. “no rate-limit mode” command can be used
to enable it.
27 snmp-server command
This command is used to configure SNMP operation of the switch.
Entering “snmp-server ?”, the sub-commands will be shown.
(config)# snmp-server ?
<1-5> Index of Trap
community Defines SNMP community access string
contact Sets the system contact string
location Sets the system location string
snmp-server community get xxx command is used to set the community string of get command for SNMP operation.
“xxx” is the community string.
snmp-server community set xxx command is used to set the community string of set command for SNMP operation.
“xxx” is the community string.
snmp-server contact xxx command is used to set the contact information for this switch. “xxx” is the contact
information string.
snmp-server location xxx command is used to set the location information for this switch. “xxx” is the location
information string.
28 sntp command
This command is used to configure SNTP protocol of the switch.
Entering “sntp ?”, the sub-commands will be shown.
(config)# sntp ?
To Next Page
Loading...
Need help?
General
