Chapter 6. Manage / Configure the Switch
47
6.2.4 Interface Configuring Commands
C
ommands in Configuring Mode are for general switch settings. And its prompt is “(config)#”.
The port interface function and VLAN group interface function are set with “interface” command.
(config)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
interface ethernet 1/x command is used to configure settings for Port x. Please refer to section 6.2.4.1 Interface
Configuring Commands for Port for the details.
interface vlan x command is used to configure VLAN Group x interface (“x” is the VLAN ID). Please refer to section
6.2.4.2 Interface Configuring Commands for VLAN for the details.
Both commands will change the prompt from “(config)#” to “(config-if)#”.
Note
: The general VLAN settings are done with “vlan database” command. Please refer to section 6.2.5 VLAN
Configuring Commands for the details. And interface vlan x command is used to assign characteristics to a VLAN
interface. For example, assigning IP address to a VLAN interface is done with this command.
6.2.4.1 Interface Configuring Commands for Port
Commands in Configuring Mode are for general switch settings. And its prompt is “(config)#”.
If the settings are for ports, it is done with “interface ethernet 1/x” command in configure mode. For example,
“interface ethernet 1/5” is for settings on Port 5.
To Next Page
Loading...
Need help?
General
