Chapter 6. Manage / Configure the Switch
80
show mac-address-table multicast command will show multicast address table for IGMP function.
For example,
# show mac-address-table multicast
Group VID Group Address Members Port
------------- ------------------------------------------------------
13. show mac-security command
This command is used to show mac address security settings on port. There are two mac address security functions
for ports. One is “accept” function that allows static mac addresses on ports to access network only. Another is “limit
by mac no.” function and up to a limit number of mac addresses are allowed to access network from the port.
For example,
# show mac-security
[MAC Security Configuration]
===========================================================
Port# Max. MAC no. Learned no. Security Control
Eth 1/ 1 0 N/A No Security
Eth 1/ 2 0 N/A No Security
Eth 1/ 3 0 N/A No Security
Eth 1/ 4 0 N/A No Security
Eth 1/ 5 10 0 Limited by MAC no
Eth 1/ 6 0 N/A No Security
Eth 1/ 7 0 N/A Accept function
Eth 1/ 8 0 N/A No Security
Eth 1/ 9 0 N/A No Security
Eth 1/10 0 N/A No Security
14. show management command
This command is used to show switch management security settings. The IP/subnet, access mode, and protocol
functions security settings will be shown.