Chapter 6. Manage / Configure the Switch
74
Rate-limit level of input: 0
Ingress rate limit: Disable
Rate-limit level of output: 0
Egress rate limit: Disable
VLAN membership mode: access
VLAN stacking role: normal
Ingress rule: Disable
Acceptable frame type: All frames
Native VLAN: 1
Untag vid: 1
Priority for untagged traffic:Low
Private-VLAN mode: Normal
IP Address of IP Filter:
Netmask of IP Filter:
7. show ip command
This command is used to show current IGMP configuration and switch IP configuration.
# show ip ?
igmp IGMP snooping
interface Interface information
redirects Default gateway configured for this device
show ip igmp snooping command will show current switch IGMP configuration.
show ip igmp snooping mrouter command will show current IGMP multicast router setting.
For example,
# show ip igmp snooping
IGMP Status: Disable
IGMP Querying: Disable
IGMP Querying: Disable
IGMP Query Interval: 125 seconds
IGMP Report Delay: 15 seconds
IGMP Query Timeout: 255 seconds