CTC Union GSW-3424M User Manual

Chapter 6. Manage / Configure the Switch
51
10 end command
This command is used to exit from interface mode.
(config-if)# end
(config)#
11 flowcontrol command
This command is used to enable flow control function of the interface port(s).
flowcontrol command is used to enable flow control function of the interface port(s).
no flowcontrol command is used to disable flow control function of the interface port(s).
12 interface command
This command is used to change the interface port(s) or interface VLAN groups for next setup commands.
(config-if)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
For example,
“(config)# interface ethernet 1/5” will set current setup interface to Port 5 and all the commands will be applied to
Port 5.
“(config-if)# interface ethernet 1/6-7” will change current setup interface to Port 6-7 and all the commands will be
applied to Port 6-7.
If “vlan” sub-command is used, current setup interface will be changed to some VLAN groups. For example,
“(config-if)# interface vlan 100” will change current setup interface to VLAN 100 and all next commands will be
applied to VLAN 100.
The description of commands in interface configuring mode is put in Section 6.2.4 Interface Configuring
Commands. Please refer to the section for the details.

CTC Union GSW-3424M Specifications

General

Brand	CTC Union
Model	GSW-3424M
Category	Switch
Language	English