35
to disable it. If it is enable, the unregistered (not joined) IP multicast traffic will
be flooded to every port. If it is disable, the unregistered (not joined) IP
multicast traffic will be flood to IGMP member ports only.
15 ip-filter command
This command is used to enable IP Filtering function on port. Only the allowed
IP addresses can access network through the switch ports.
ip-filter command is used to enable this function. “no ip-filter” command is
used to disable this function.
And assigning the filtering IP/Subnet to ports is done by “ip-filter” command in
“(config-if)#” mode (go with “interface ethernet 1/x” command. “x” is the port
number.) Please refer to “ip-filter” command in Section 6.2.4.1 for the details.
16 lacp command
This command is used to configure LACP function of the switch. Entering “lacp
?”, the sub-commands will be shown.
(config)# lacp ?
system-priority Combined with MAC address to form LAG identifier
lacp system-priority x command is used to configure the system priority for
LACP operation of the switch. Its value is 1~65535 and higher numbers have
lower priority. Combining with the Mac address of the switch, it is used to
identify this switch in LACP protocol operation.
Adding ports to LACP trunk group is by “lacp” command in “Interface
Configuring Commands for Port”. Please refer to Section 6.2.4.1 for the details.
17 logging command
This command is used to configure logging function of the switch. The logging
function can record events at local flash or remote log server. Entering “logging
?”, the sub-commands will be shown.
(config)# logging ?
log-level Log level
on Enable logging to all supported destination
remote-log Enable logging to remote host
logging log-level x command is used define the log level of events. The valid
value of “x” is 0~7.
logging on command is used to enable the logging function. And no logging
on command is used to disable the logging function.
logging remote-log command is used to configure remote logging function.
Entering “logging remote-log ?”, the sub-commands will be shown.
(config)# logging remote-log ?
<1-5> Index
To Next Page
Loading...
Need help?
General
