EasyManuals Logo

CTC Union GSW3208M User Manual

CTC Union GSW3208M
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
36
<cr>
logging remote-log command is used to enable the remote logging function.
Events will also be sent to syslog servers. no logging remote-log command
is used to disable it.
logging remote-log x host y.y.y.y command is used to set IP address
(y.y.y.y) to syslog server with index x. Up to five (x=1~5) syslog servers are
supported.
18 mac-address-table command
This command is used to configure functions for Mac address table of the
switch. Entering “mac-address-table ?”, the sub-commands will be shown.
(config)# mac-address-table ?
aging-time Aging time for entries in the address table
static Sets MAC address table static information
mac-address-table aging-time x command is used to set to aging time of the
switch. The valid value of “x”(aging time in seconds) is 10-1000000 and 0. If
x=0, the aging operation will be disable.
mac-address-table static x-x-x-x-x-x interface ethernet 1/y command is
used to assign a static Mac address x-x-x-x-x-x to Port y of the switch. The
static mac address will not be aging out by the switch.
19 management command
This command is used to setup the management interface security function.
The management interface security function can limit the IP / subnet / remote
interfaces(http,telnet,snmp) / access right(view,modify) for management from
network. Different administrators could have different rights to manage this
switch. This is for security of this management switch. (Four user groups are
supported for this function.)
Entering “management ?”, the sub-commands will be shown.
(config)# management ?
<1-4> Index
(config)# management 2 ?
enable Set enable for a specified set
ipaddr Set IP and net mask for a specified set
mode Set mode for a specified set
protocol Set protocol for a specified set
management x enable command is used to enable the security settings for
some user groups (“x” is the index of the user group). And no management x
enable command can be used to disable it. And users for this setting are
allowed to manage this switch remotely.
management x ipaddr y.y.y.y z.z.z.z command is used to set the IP/subnet for
some user groups (“x” is the index of the user group, y.y.y.y is the IP address,
z.z.z.z is the IP subnet mask). Users in this IP subnet will belong to this users

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CTC Union GSW3208M and is the answer not in the manual?

CTC Union GSW3208M Specifications

General IconGeneral
BrandCTC Union
ModelGSW3208M
CategoryNetwork Router
LanguageEnglish

Related product manuals