37
groups.
management x mode modify/view command is used to set the access right
for some user groups (“x” is the index of the user group). If “management x
mode modify” command, users in this groups have “modify” right for
management. If “management x mode view” command, users in this groups
have “view” right only.
management x protocol http|snmp|telnet command is used to enable the
remote management protocol for some user groups (“x” is the index of the user
group). More than one protocols can be enabled at the same time - e.g.
“management 2 protocol http snmp telnet”. And no management x protocol
command is used to disable all remote management protocols for the user
group.
20 mirror command
This command is used to enable mirror function of the switch. And no mirror
command can be used to disable mirror function of the switch.
21 mvr command
This command is used to configure MVR (Multicast VLAN Registration)
function. VLAN function will isolate traffic between VLAN groups. But it will
also isolate IP multicast traffic for subscribers in different VLANs. The MVR
function allows one multicast VLAN to be shared by subscribers in different
VLANs. That can reduce the multicast traffic for VLANs.
** Before configuring MVR function, complete the VLAN setting first
** Using MVR function, you have to enable IGMP snooping function first.
This switch supports three MVR VLANs. They are referred with their VLAN ID.
For any MVR setting, you have to assign the VLAN ID in the command.
Entering “mvr x ?”, the sub-commands will be shown. “x” is a VLAN ID with
number in 2~4094. For example, “mvr 10”.
(config)# mvr 10 ?
8021p-priority Configure 802.1p priority tagging
active Active a MVR VLAN
group Create a multicast group for MVR VLAN
mode Set MVR VLAN operation mode
name Set MVR VLAN name
<cr> Create a MVR VLAN
mvr x command is used to create a MVR VLAN with VLAN ID “x”. “no mvr x”
command is used to delete a MVR VLAN.
mvr x 8021p-priority y command is used to set the 802.1P priority (0~7) for
MVR operation. The IGMP control packets for this VLAN will be assigned this
priority when tag is added. “x” is the MVR VLAN ID. “y” is the 802.1P priority
value.
mvr x active command is used to set the MVR VLAN to “active” state. “x” is the
MVR VLAN ID. “no mvr x active” command is used to set the MVR VLAN to