38
“inactive” state.
mvr x group yyy start-address m.m.m.m end-address n.n.n.n command is
used to create a IP multicast group for the MVR VLAN. After MVR VLAN is
created, you can assign IP multicast groups (video channels) to the MVR VLAN.
And you can assign more than one IP multicast groups (video channels) to one
MVR VLAN. “x” is the MVR VLAN ID. “yyy” is the name of the IP multicast
group. “m.m.m.m” is the start IP multicast address. “n.n.n.n” is the end IP
multicast address. For example, “mvr 10 group abc start-address 224.0.0.1
end-address 224.0.0.2”. “no mvr x group yyy” command is used to delete the
IP multicast group named “yyy” from MVR VLAN “x”.
mvr x mode compatible / mvr x mode dynamic command is used to set the
operation mode of the MVR VLAN. There are two operation modes for this
MVR function. One is Dynamic mode. Another is Compatible mode. In
Dynamic mode, the switch will send IGMP reports to every MVR source port in
the MVR VLAN. In Compatible mode, the switch will not send IGMP reports.
“x” is the MVR VLAN ID.
mvr x name yyy command is used to assign a name to the MVR VLAN. “x” is
the MVR VLAN ID. “yyy” is the name string.
After MVR VLAN is created, source port of IP multicast traffic and receiver ports
of subscribers will be assigned next. Assigning source port and receiver port to
MVR VLAN is done in “(config-if)#” mode (go with “interface ethernet 1/x”
command. “x” is the port number.) Please refer to “mvr” command in Section
6.2.4.1 for the details.
22 no command
This command is used to disable a function or restore a setting to factory
default of the switch.
(config)# no ?
aaa AAA Service
automode Set Auto Negotiation or Auto Detect mode
dhcp-relay Set Auto Negotiation or Auto Detect mode
dot1x Configures 802.1x port-based access control
hostname Sets system's network name
ip Global IP configuration sub commands
ip-filter Enable IP address filtering function
lacp Configures LACP status
logging Modifies message logging facilities
mac-address-table Configuration of the address table
management Specifies management IP filter
mirror Configuration of mirror
mvr Multicast VLAN Registration
qos Configuration of QoS
queue Assigns priority queues
radius-server Configures login to RADIUS server
rate-limit Configures rate-limits
snmp-server Modifies SNMP server parameters
sntp Simple Network Time Protocol configuration
To Next Page
Loading...
Need help?
General
