CTC Union GSW3208M - Page 72

72
!
SNTP server 220.130.158.54
!
……
……
!
interface ethernet 1/10
port-vlan 1 Default_VLAN
!
!
!end
22. show rate-limit command
This command is used to show rate limit settings.
For example,
#show rate-limit
Ingress Drop Mode: Enable
Rate Control Unit(Kbps): 128
[Rate Control Configuration]
Port Ingress Egress
================================================
1/1 No Limit No Limit
1/2 No Limit No Limit
1/3 No Limit No Limit
1/4 No Limit No Limit
1/5 No Limit No Limit
1/6 No Limit No Limit
1/7 No Limit No Limit
1/8 No Limit No Limit
1/9 No Limit No Limit
1/10 No Limit No Limit
23. show snmp command
This command is used to show SNMP configuration of the switch.
For example,
# show snmp
[SNMP Configuration]
Object ID : 1.3.6.1.4.1.x.60.10
System up Time: 597 (seconds)
System Name :
Location :
Contact name :
Get Community : public
Set Community : private
[Trap Community]
ID Status Community IP Address
1 Disabled public 0.0.0.0
2 Disabled public 0.0.0.0
3 Disabled public 0.0.0.0