73
4 Disabled public 0.0.0.0
5 Disabled public 0.0.0.0
Version: V3V2cV1
Username: admin
SnmpSecurityLevel: noauth
Authentication: MD5
Privacy: Des
24. show sntp command
This command is used to show system time settings of the switch.
For example,
# show sntp
====================================
[Time Configuration]
====================================
Get Time By : Manually
Time Server : 220.130.158.54
Time Zone : Japan(+9)(37)
Current Time : 1970/01/01-09:29:45
D.S.T. status: Disable
D.S.T. start : 1st/SUN/JAN/0:00
D.S.T. end : 1st/SUN/JAN/0:00
====================================
* D.S.T. Is Daylight Saving Time.
25. show spanning-tree command
This command is used to show spanning tree configuration of the switch.
show spanning-tree command is used to show all spanning tree configuration
(for bridge and ports).
show spanning-tree ethernet 1/x command is used show spanning tree
configuration of Port x. (“x” is the port number.)
For example,
# show spanning-tree ethernet 1/5
Bridge Port Number: 5
Port Priority (0..255): 128
Port State: Linked Down
Port Enable : Enabled
Is edge : No
Port Path Cost(1..65535): 19
Port Designated Root: 00:00:00:00:00:00 [ 0 ]
Port Designated Cost: 0
Port Designated Bridge: 00:00:00:00:00:00 [ 0 ]
Designated Port: 5: [ 128 ]
Port Forward Transitions: 0
Port Role: Nonstp
Point To Point: Yes
To Next Page
Loading...
