87
This is used to setup the IP addresses that can manage this switch. They have
different access rights set in “Mode”. And the remote management interfaces
(Http/Telnet/SNMP) could be enable/disable for different administrators. This
function is for security policy of switch management.
Note:
Remember to enable at least one IP/Subnet with Modify right for Http/
Telnet/SNMP interface. Otherwise, configuring switch from remote will become
impossible. In that case, you can manage the switch from console only.
2). Mac Security Configuration
There are two Mac ID security modes for the switch. One is Static Mac ID Filter
on Port, another is Dynamic Mac ID Number Limit on Port.
[ Static Mac ID Filter on Port ]
This function can limit only those static Mac addresses on the port can access
To Next Page
Loading...
Need help?
General
