88
network. Other Mac addresses will be rejected by the port. Sometimes it is called
“Mac-Port Binding”.
Follow the steps to configure it.
a. Set the “Security Control” to “Accept” on those ports that will apply static Mac
ID security. Then click [Apply].
b. Set Static Mac Addresses that are allowed for network access at [Static
Address] of [Address Table] function. Please refer to that section for the
details.
[ Dynamic Mac ID Number Limit on Port ]
This function can limit the Mac ID number to access network through a port. For
example, five Mac ID are allowed for Port 2. That means up to five users are
allowed, but don’t care who the users are.
Follow the steps to configure it.
a. Set the “Security Control” to “Limited by MAC no.” on those ports that will
apply dynamic Mac ID number security. And set the “Max. MAC no.” to the
users number allowed on the ports.
b. Then click [Apply].
The switch will learn users automatically and show current user number at
“Learned no.”.
3). 802.1x Configuration
If 802.1x function is enabled, the switch will act as an authenticator for users
accessing network through the switch. It needs a RADIUS server for the
authentication function. Users will be asked for username and password before
network access. If the RADIUS server authenticates it, the switch will enable the
port for network access. This function is very useful for network security
application to prevent illegal users access network through the switch.
To Next Page
Loading...
Need help?
General
