96
Click [Apply] after the setting.
b. Select the Port Number.
c. Enter the rate limit level for Ingress and Egress traffics. “0” means NO LIMIT.
Click [Apply] after the setting.
About “Packet Drop for Ingress Limit” function ...
When Ingress traffic rate exceeds Ingress Rate Limit, the switch can drop packets
or pause the traffic. If packet drop is enabled, flow control of ports will be disabled
and packets could be dropped. If packet drop is disabled, flow control of ports will
be enabled and pause frame will be sent when ingress traffic rate exceeds the
limit.
5-2) Storm Control Configuration
This function can setup the broadcast, multicast, and unicast storm rate of the
switch.
Please follow the rules in table to setup the maximum storm rates.
Note
: The storm rate is counted by pps (packet per second).
6). Port Statistics
To Next Page
Loading...
Need help?
General
