1.6 Panel 1000M 1000MS
LED Indicators
(see next page)
1 x RJ-45 port, supports
10/100/1000M Ethernet
The LAN Speed and Fiber Speed LEDs
use dual color to indicate speed.
Green indicates Fast Ethernet (100M).
Amber indicates Gigabit Speed.
Fixed
GbE Optical
Transceiver
When off, the LAN Speed LED
1 x SFP port, supports any
155M or 1.25G transceiver
indicates 10M speed.
Factory reset procedure
Apply power to 1000M(S).
Allow 30 seconds to fully boot.
Using a pencil or ball-point pen, press the
'DEFAULT' recessed push-button switch (located
on the face plate) and hold for 6 seconds. The unit
will be restored to factory default almost
immediately. The defaults are:
Figure 1. Panel Graphics
DEFAULT:
Use to recover from lost password or to return
all settings to factory default values.
IP=10.1.1.1
netmask=255.255.255.0
GW=10.1.1.254
password reset to 'admin'
10
To Next Page
Loading...
