10
Basic Functions
Turning on/off your CTOUCH interactive
display
Standby Setup: The AC power cord must be set up and connected to get the CTOUCH
interactive display in standby mode ready to be turned on.
Press the Power button on the front panel to make the CTOUCH interactive display go into
standby mode.
1
If the CTOUCH Interactive display is in standby mode, press the Power button on the remote
control or CTOUCH interactive display itself to turn the CTOUCH interactive display on.
Power button
2
Press the Power button again on the remote control or the CTOUCH interactive display itself to
turn the CTOUCH interactive display off.
Using the touch sensor
To operate the touch sensor, connect the USB cable from a computer to the Sensor USB, and
then turn on the computer.
To Next Page
Loading...
