Cub Cadet 8354 - Brake Case; Disassembly and Assembly

BRAKE
6-9
D615-W02 May-2003
615W608A
7.1 DISASSEMBLY AND ASSEMBLY
A. Disconnection of Brake Case Group
a. First Stage (Disconnection of Brake Case)
(1) Bolt
(2) Nut
(3) Brake Case
(4) Lever Shaft
(5) Stud
1. Disengage bolt (1) and nut (2) and disconnect brake
case (3) in assembly.
(When reassembling)
• Make sure assembly position of lever shaft (4), bolt
(1), and stud (5) is correct. Assembly position: see
figure and following table.
• Apply ball seat (8) with grease sufficiently and make
sure ball (9) not escaped.
Bonding agent Three bond 1372 or equivalent
(6) Packing
(7) Packing
(8) Ball Seat
(9) Ball
• Replace packing (6) and (7).
• Apply stud (5) with bonding agent.
7. BRAKE CASE
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983