CHAPTER 8 8354/8404
8-22
D615-W02 May-2003
615W843A
(5) Steering Cylinder Assembly
(7) Support Pin
(10) Spacer Barrel
(When reassembling)
• When attaching steering cylinder with center pin,
make sure assembly position of spacer barrel (10)
is correct (See the following figure).
615W842A
(1) Steering Hose Assembly R
(2) Steering Hose Assembly L
(3) Split Pin
(4) Nut
(5) Support Pin
(6) Support Pin
(7) Steering Cylinder Assembly
(8) Center Pin
(9) Bolt
(10) Nut
B. Disassembly, Assembly
a. Disconnection of Steering Cylinder Assembly
• Disconnect steering hose assembly (1) and (2).
• Pull out split pin (3) and disengage nut (4).
• With tapping the end of support pin (5) using plastic
hammer, pull out support pin from front axle case.
• Disengage pin (6) locking bolt (9) and pull out pin
from center pin (8).
• Disconnect steering cylinder assembly (7).
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983
To Next Page
Loading...
