Cub Cadet 8354 - Page 263

HYDRAULIC SYSTEM
9-29
D615-W02 May-2003
615W933A
(1) Screw (13) Flange
(2) Bolt (14) Clutch Hub
(3) Lock Washer (15) Spring
(4) Gasket (16) Bolt
(5) Support (17) Lock Washer
(6) Pitman Arm (18) Bolt
(7) Clutch (19) Shaft
(8) Spring (20) Clutch
(9) Bolt (21) Control Lever
(10) Clutch Hub (22) Snap Ring
(11) O-Ring (23) Screw
(12) Snap Ring
c. Hydraulic Control Lever
1. Disengage screw (1) assembled into cylinder as-
sembly inside link.
2. Disengage bolt (2) and remove relevant parts
entirely.
615W931A
(When reassembling)
Tightening
torque
48.1 ~ 55.8 N·m
4.9 ~ 5.7 kgf·m
35.5 ~ 41.2 lbf·ft
Hydraulic
cylinder
attaching
bolt, nut
1. Disengage joint bolt (1).
2. Disengage the hydraulic cylinder assembly mount-
ing bolts [(6), (7), (8), (9)], spring washer (5) and nut
(4).
3. Raise and then detach the hydraulic cylinder as-
sembly with a nylon rope supported.
(1) Joint Bolt
(2) O-Ring
(3) Hydraulic Pipe 2
(4) Nut
(5) Spring Washer
b. Hydraulic Cylinder Assembly
(6) Bolt
(7) Bolt
(8) Bolt
(9) Bolt
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983