8-38 Periodic Maintenance and Adjustment
Brake light switch adjustment
The brake light switch, which is activated by
the brake pedal, is properly adjusted when
the brake light comes on just before braking
takes effect. If necessary, adjust the brake
light switch as follows.
1. Open the hood. (See pages 8-8 for
hood opening and closing procedures.)
2. Turn the adjusting nut while holding the
brake light switch in place. To make the
brake light switch in place. To make the
1. Locknut 2. Adjusting nut
6. Turn the adjusting nut in direction to
increase the free play or in direction
to decrease the free play.
7. Tighten the locknut.
8. Install the console.
9. Install the seats.
brake light come on earlier, turn the
adjusting nut in direction . To make
the brake light come on later, turn the
adjusting nut in direction .
To Next Page
Loading...
Need help?
General
