EasyManuals Logo

Cub Cadet Challenger 500 User Manual

Cub Cadet Challenger 500
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
5-12 Pre Operation Checks
Set pressure with tires cold. Set tire pressures
to the following specifications:
Recommended
Pressure
Minimum Maximum
Front
10psi (70kpa
(0.70kgf/ cm
2
)
9 psi (63kpa,
0.64kgf/ cm
2
)
11 psi, (77kpa,
0.77kgf/
cm
2
)
Rear
10psi (70kpa
(0.70kgf/ cm
2
)
9 psi (63kpa,
0.64kgf/ cm
2
)
11 psi, (77kpa,
0.77kgf/ cm
2
)
How to measure tire pressure
Use the tire pressure gauge.
NOTE:
The tire pressure gauge is included as standard
equipment. Make two measurements of the tire
pressure and use the second reading. Dust or
dirt in the gauge could cause the first reading to
be incorrect.
1. Tire pressure gauge
5. Use no more than the following pressures
when seating the tire beads.
Front 36psi (250kpa, 2.5kgf/cm
2
)
Rear 36psi (250kpa, 2.5kgf/cm
2
)
Higher pressures may cause the tire to burst.
Inflate the tires very slowly and carefully. Fast
inflation could cause the tire to burst.

Table of Contents

Other manuals for Cub Cadet Challenger 500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet Challenger 500 and is the answer not in the manual?

Cub Cadet Challenger 500 Specifications

General IconGeneral
BrandCub Cadet
ModelChallenger 500
CategoryUtility Vehicle
LanguageEnglish

Related product manuals