20 OPERATING
Engine Inclination
Thisenginewill operateconlJnuouslyat anglesup
to 25° in any direction.
Refer to the operating instmc'donsofthe equip-
ment this engine powers. Because of equipment
designor application,there may be more stringent
restrictionsregardingthe angle ofoperation+
CAUTION
Do not operate this engine continuously at
angles exceeding 25Qin any direction. En-
gine damage could result front insufficient
lubricaf_on.
STOPPING
STOPPING 21
Stopping the Engine
Ordinary Stop
• Movethrottlelever(A) to SLOW position.
• Lowerthe enginespeed to an idle. Keep running
at idle for aboutone minute.
CAUTION
Engine damage can occur from run.on or
after-burning If engine is stopped suddenly
fi'om high speed loaded operation. Reduce
engine speed to Idle for one minute before
shutting engine off.
•Tum the engine switchorthe switchkeyto "OFF"
For ControlPanel SwitchType, move the throttle
leveragainstitslow speed end toturns ignitionoff+
• Immediatelytum the engineswitc_ or the _,vitc_
key to "OFF" position.
• Closethefuel valve on theequipment.
ForControlPanel Switch Type, move the throttle
lever on the equipmentagainst itslow speed end.
Movingthe lever againstits lowspeed endturns ig-
nitionoff,
m $
Always remove Engine Key from switch
when leaving equipment unattended or
when equipment i$ not in use.
41
To Next Page
Loading...
Need help?
General
