EasyManuals Logo

Cub Cadet RZT 50 User Manual

Cub Cadet RZT 50
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
18 STARTING
CAUTION
DO not run the electric starter continuously
for more than 5 seconds, otherwise the bat-
tery may discharge quickly, If the engine
does not start right away, wait 15 seconds
and try again.
CAUTION
Whenever you start engine, make sure warn.
Ing light Is not Illumlnatad after engine starts.
If warning light comes on, stop engine imme-
diately and check oil level (If equipped).
OPERATING 19
Warming Up
After the engine starts, move the throttle lever (A)
on the equipment to halfway between "FAST" and
"SLOW'.
To warm up the engine, run it for 3 to 5 minutes
with the throffie lever in the same load position
(halfway) before putting the equipment under load.
Then, move the throttle lever (A) on the equipment
to its "FAST" position.
CAUTION
Allow engine to warm up sufficiently (3 to 5
minutes at idle) before applying a load. This
will allow oil to reach all engine parts, and
allow piston clearance to reach design spec-
ifications.
CAUTION
While warming up the engine, make sure the
warning light (oil pressure) on dash is not
on. The warning light must not be illumi-
nated during engine operation (if equipped).
4O

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet RZT 50 and is the answer not in the manual?

Cub Cadet RZT 50 Specifications

General IconGeneral
Engine BrandKohler
Engine Displacement725cc
Horsepower24 HP
Cutting Width50 inches
Fuel Capacity3.5 gallons
TransmissionHydrostatic
Deck MaterialSteel
Deck ConstructionStamped
TypeZero-Turn
Cutting Height1.5 - 4 inches
Turning RadiusZero
Engine ModelCourage
Warranty3 years limited

Related product manuals