© CUB CAMPERS • C16 OWNER’S MANUAL • REVISION 1 - 6/02/2023 PAGE 18 of 59
2. Grasp the leg near its hinge-joint and pull it toward you.
3. Unhook the leg.
NOTE: The foot for leg A has been designed to prevent its incorrect placing inside the housing
of the lead bar during the closing phase of the awning. With an incorrect placing of the foot
the lead bar will not close completely; we advise you to always put it into the housing properly
with the base turned to the lead bar.
4. Lower the leg as shown in the figure.
5. After unrolling the awning completely,
adjust the legs at the chosen height.
To Next Page
Loading...