Cub C16 - Page 32

To Next Page

To Previous Page

SETTING UP AND USING YOUR TOILET

1. Press top button and open the access door on the outside of the caravan using key

provided if required.

2. Rotate the waste tank emptying spout 90° and remove the water filling extension

3. Rotate the water fill funnel outwards, remove the cap, and place the extension on the

water fill funnel. Add the recommended amount of fresh-water additive (See sample

Thetford AQUA RINSE in the bottom drawer of inside kitchen) to the water tank for a

better and cleaner flush that also keeps the water in the flush tank fresh.

4. Fill the rest of the water tank with clean water.

5. Remove the extension and return to its original position on the waste tank.

WARNING: Keep water level below the top of the water filling tunnel.

NOTE: 150ml of water will remain in the water fill funnel when the water tank is empty.

6. Remove the waste tank by pulling the safety catch upwards.

7. Pull the waste tank outward to the stop. Tip it slightly and take the tank fully out.

8. Place the tank upright and turn the emptying spout upwards.

9. Remove the cap, pour the stated quantity of toilet fluid into the waste tank (use cap

with measuring cup and sample bottle of AQUA KEM BLUE toilet fluid in bottom drawer

of inside kitchen). This avoids unpleasant smells in the waste tank and keeps the inside

of the waste tank clean. Next add approximately 2 litres of water – enough to ensure

that the bottom of the waste tank is covered. Screw the cap back onto the emptying

spout. Turn the emptying spout back to its original position.

WARNING: Never add toilet fluid via the valve blade or via the toilet bowl.