Cuddeback C - Command List and Settings; Image Aspect Ratio; Zone Control Setting; Image Size Selection

4. ASPECT – this selects the format of the image.
Select WIDE view or FULL view. WIDE is the modern
16 x 9 format, and FULL is the traditional 4 x 3 format.
5. ZONE – this setting should match the setting of
the front panel Zone Control. Set to WIDE when
the Zone Control shutter is down. Set this to
CENTERED when the Zone Control shutter is up.
6. IMAGE SZ – select 5MP or 20MP.
7. LAPSE SZ – select 1MP, 5MP, or 20MP. Note,
the bigger the image size the more space on the SD
card is required. We recommend 1 MP when time
lapse is set to 1 minute or less.
8. CAM ID – Select a number from 0 to 9999 to
have printed on to the image. is can be used for
easier image identication.
9.
DST MODE – Daylight Savings Time. For USA
users you can have the camera automatically adjust
for spring and autumn daylight savings time changes.
Press UP or DOWN to select AUTO or OFF. In AUTO
mode DST clock adjustments are done automatically.
10. IM COPY – Use this command to copy images
from the cameras internal memory to the SD card.
11. SETUP – You can change setup mode to
ADVANCED
(ADV) or EZ. Default mode is EZ.
Advanced Mode enables numerous additional
features. Press UP or DOWN to change Setup Mode
from EZ to Advance. See Advanced Mode section
latter in this manual.
12. STATS – Displays operating history statistics.
Press UP or DOWN to display: Activation Date,
Lifetime Days, Run Days, Lifetime Images, Lifetime
Flash images.
✓ Activation Date is the day your warranty begins.
It is set automatically when batteries are installed.
✓ Lifetime Days is how many days the camera
has been operating.
✓ Run Days is how many days the camera has
been armed.
✓ Lifetime Images is how many images the camera
has recorded.
18 19