CUH SDVC31 Series - Logical Relation Setting of the Intelligent Photoelectric Sensor

CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH CUH
18
SDVC31 Series
Variable Frequency Digital Controller for Vibratory Feeder
SDVC31SMSEN_4.012023-08
Under normal circumstances, the receiving end receives no optical signal, and
the controller runs by default. But in some special applications the controller
needs to be stopped when the receiving end receives no optical signal.
Adjusting this parameter can fulfill this kind of application.
5.2.2 Logical Relation Setting of the Intelligent Photoelectric Sensor
Variable Frequency Digital Controller
for Vibr
atory Feeder
Variable Frequency Digital Controller
for Vibratory Feeder
Saturated
Saturated
Accelerate
Accelerate
Remote
Remote
Stop
Stop
Lock
Lock
Voltage
Voltage
Frequency
Frequency
On Delay
On Delay
Off Delay
Off Delay
Soft Start
Soft Start
SDVC31-M
SDVC31-M
8Long press and ▲
simultaneously to enter the
advanced parameter interface.
8Short press to switch to
Parameter Γ1.
8Press ▲ or ▼ to adjust the
parameter value.
Normal Close
Normal Open
Parameter Γ1 is set to ___ by default.
lWhen Parameter Γ1 is set to___, namely no optical signal received, the controller
runs.
lWhen Parameter Γ1 is set to_-_, namely no optical signal received, the controller
stops.